Du Ha 20025 Návod k použití a péči stáhnout pdf

Materials Needed:

// 8mm Socket

Installation Instructions: Solid Bench Seat

Tilt the back of the rear seat forward.

Remove the jack handles from the current plastic tray (if applicable). Using an 8mm

socket, remove bolts holding current plastic tray. Remove tray from truck. (Note: If you

experience problems removing bolts you may need to apply upward pressure from under tray.)

Turn the DU-HA upside down. Using clear tape, tape the two spacers directly over the

pre-drilled holes in the bottom front of the DU-HA, directly above the DU-HA lettering.

Turn the DU-HA back over. Line up the DU-HA so the pre-drilled holes are directly above

the holes in the oor of the truck, with the DU-HA lettering facing forward.

(Note: The spacers are designed to keep the back seat from hitting the DU-HA when the seats are in their

upright position. If the seat still hits, add extra washers.)

Screw in each bolt using an 8mm socket. Do not overtighten.

If desired, install organizer/gun racks with plastic stiffeners by snapping them into the

slots in the DU-HA (as pictured). Gun racks can be installed to hold two guns or one gun

depending on how you install them. If you removed your jack handles from the existing

tray you can place the jack handles in DU-HA or on oor in front of DU-HA.

Safety Instructions:

Warning: Seat back must be latched up at all times

while vehicle is moving. Make sure the DU-HA is

secured in the vehicle according to installation

instructions. Do not store explosives or hazardous

materials in the DU-HA. Do not place loaded

guns in the DU-HA.

For further instructions refer to truck owners

manual or contact DU-HA, Inc.

00-07 Ford F-250—F-550 Super Duty Crew Cab & Reg. Cab

Behind-the-Seat Storage

Installation Instructions

DU-HA, Inc. // website: www.du-ha.com // phone: 1.866.306.DUHA (3842) // fax: 1.218.998.4013 // 306 Saint Andrews Street South, Fergus Falls, MN 56537

Fits DU-HA Part Numbers

Part Description Qty

A DU-HA Storage Unit 1

B Foam Organizer / Gun Rack 2

C Plastic Stiffener 2

D Spacers - 13RS075009 3/4”x.5” 2

E Nylon Strap with Buckle 2

20020

20022

20025

20032

2 straps are

included to

help secure

guns/gear in

place.

DIVIDER – 20020

1 2

Shrnutí obsahu

Strany 1 - Installation Instructions

Materials Needed: // 8mm SocketInstallation Instructions: Solid Bench Seat Tilt the back of the rear seat forward. Remove the ja

Strany 2

Materials Needed: // Phillips Screwdriver // 13mm Socket // 8mm SocketInstallation Instructions: 60/40 Split Bench Seat Tilt th

Komentáře k této Příručce

Žádné komentáře

Du Ha 20025 Návod k použití a péči

Procházejte online nebo si stáhněte Návod k použití a péči pro ne Du Ha 20025. Du Ha 20025 Use and Care Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce